Power UNITS FOR LIFT TABLE

Energy UNITS FOR LIFT TABLE one
General Description
This electrical power unit is intended exclusively for your smaller lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This electrical power unit continues to be extensively utilized in the sector of logistic products which include minifork lift, scissors lift and ariel functioning platforms. The lower-ing movement is controlled by the solenoid valve using the velocity controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE two
Basic Description
This power unit is made exclusively for that medium lift table, Consisting of remarkably effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering movement is actived from the solenoid valve and the velocity managed from the adjustable needle valve. When the lift rises to a substantial positoin, however the energy provide is cut, the lowering movement is managed through the guide override perform.
Electrical power UNITS FOR LIFT TABLE 3
Common Description
This energy unit is developed exclusively for your substantial lift table, Consisting of remarkably effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve as well as the speed controlled by a stress compensated movement control valve.
Energy UNITS FOR LIFT TABLE four
General Description
This electrical power unit is made solely for your huge lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived through the solenoid valve and also the velocity controlled from the adjustable needle valve. When the lift rises to a large positoin, but the electrical power provide is cut, the decreasing movement is managed by the manual override function.
Particular Notes
one. This electrical power unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
two. Clean every one of the hydraulic components concerned prior to set up of the power unit.
3. Viscosity on the oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is proposed.
four. Oil transforming is needed soon after the original a hundred operation hours,afterwards after every single 3000 hours.
five. The electrical power unit proven is made to be mounted vertically.